6. Once the adhesive pad is level and aligned with the taped reference
line, press the pad to the mounting surface firmly to ensure proper
adhesion and to eliminate any trapped air bubbles.
NOTE:
The adhesive wet area (the total area of the adhesive
that is free of air bubbles or debris) must be 60% or greater.
Attach the Angled Bracket
1. Use pliers (or a similar tool) to break away the appropriate knockout
on the left, right, or bottom of the angled bracket for running cables
to the touch screen.
2. Remove the protective covering from the front of the adhesive pad.
3. Hold the angled bracket at a 45-degree angle to the adhesive pad,
and then align the lower edge of the bracket with the lower edge of
the pad. Do not allow the bracket to come in contact with the
adhesive.
4. Once the angled bracket is level and aligned with the adhesive pad,
press the bracket to the pad firmly to ensure proper adhesion and to
eliminate any trapped air bubbles.
NOTE:
The adhesive wet area (the total area of the adhesive
that is free of air bubbles or debris) must be 60% or greater.
Attach the TSW-770/1070 Mounting Bracket
1. Remove any existing tape guides and install any raceway (not
included) to conceal cables running to the desired knockout on the
angled bracket.
NOTE:
To ensure the raceway fits into the knockout, Crestron
recommends using raceway with the following
dimensions: 0.45 H x 0.77 in. W (11 x 20 mm).
5
TSW-770/1070-MSMK-ANG
Quick Start
Multisurface Mount Kit for TSW-770 and TSW-1070 Series, Angled