LOCATING THE SENSORS:
SENSOR INSTALLATION:
1. Carefully measure and mark sensor locations. Measure,
double-check and check again. You are making permanent
modification to the vehicle, make sure spacing and angles
are correct!
2. Use the supplied 22MM hole sale drill to make sensor holes.
3. Route cable through hole.
4. Gently press in sensor. Hole clearance is critical, make sure
sensor fits snugly, but not over-tight. Crushed sensors will
provide inaccurate readings and false alarms.
SENSOR ANGLE:
SIDE VIEW
Horizontal
NO!
Ground may interfere
with sensor.
0-10 degree upward
Optimum
performance
Downward
O.K.
(May not detect
small or low to
ground objects.)
WARNING! Before drilling the hole, make sure that the sensor will not be angling
towards the ground causing the sensor to continuously beep!
