CONVENIENCE AND SAFETY FEATURES
HOOD OPEN SAFETY (Requires grounding hood pin installation)
This feature prevents the engine from being remote started when hood is open. Helps eliminates risk of injury to
someone working under the hood of the vehicle with a properly working hood pin installed. If Remote Start button
is pressed with the hood open, the unit will not attempt a start.
BRAKE PEDAL RESET
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents
unauthorized tampering. This circuit shuts the system down immediately when brake pedal is pressed if the key is
not in ignition and turned to the ON position.
OEM ALARM INTERFACE
This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start
and keyless entry (if needed for your vehicle). This feature will maintain the original integrity and security of your
vehicle’s factory equipped systems before, during, or after remote start.
NOTE:
When changing, charging, or jumpstarting the vehicle’s battery we recommend removing the main power fuses
located on the heavy gauge RED wires near the remote start module.
TRANSMITTER PROGRAMMING
Note: All transmitter codes must be learned at time of programming!! The CoolStart system learns up to 4
different transmitter codes.
1. Open Hood (If no hood pin installed with your system, then you must ground the Gray Hood pin wire).
2. Turn key to the ON position. (Do not start vehicle)
3. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.
4. Press Lock Button #1 of the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting
for a 2
nd
code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for
the 3
rd
code and so on. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise
turn key off and close hood. See diagram next page.
9
