6
USING THE 2-WAY PAGER TRANSMITTER
The 2-Way LCD Pager remote transceiver is used to send and receive information from the vehicle. The
Control Module transmits High Frequency FM signals from the vehicle to your pager over long distances. Your
range will vary depending on location, terrain, and local RF noise/interference. This system is not guaranteed to
page you if you are behind concrete walls, underground, in a large structure, or in an area with high levels of
electronic interference. Handle the pager/remote with care. The LCD display and/or the electronics may be
damaged if subjected to abuse.
BATTERY CHARGING
The 2-Way LCD remote has a battery charge indicator on top right corner of display. The battery voltage affects the
distance of the remote control. The system comes with a standard Mini USB charging cable that plugs into the side
of remote control. To access to USB plug, slide the cover to the left shown below.
SETTING THE CLOCK (2-WAY- LCD REMOTE)
1. Press VEH Button on the side of the remote control 5 times.
2. The remote will beep and the
AM or PM
display will begin flashing.
3. Press the Trunk Button to go to the next item
–
AM - PM - Hour- Minutes
.
4. Press the Lock Button to
Increase
time.
5. Press the Unlock Button to
decrease
time.
6. Press the Start Button to
Disable or Enable Beep and Vibration.
See next page.
7. Press the VEH Button to
Save and Exit Setup
or wait 8 seconds, the LCD light will turn off.
USB Charging Port
