15
BUTTON 5
(On side of remote):
·
Press and release to light up
the LCD screen.
·
Press and release twice to
recall the last message from
the LCD screen.
·
Press and Hold two seconds
to change from Car 1 to Car 2
or Car 2 to Car 1.
·
Press 5 times to change the
Time and audible beep tones
on the remote.
OPERATION INSTRUCTIONS (TRANSCEIVER / PAGER-REMOTE)
PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send and receive
information from the vehicle. The Control Module transmits High
Frequency AM/FM signals from the vehicle to your over long
distances. Your range will vary depending on location, terrain, and
local RF noise/interference. This system is not guaranteed to page
you if you are behind concrete walls, underground, in a large
structure, or in an area with high levels of electronic interference.
Handle the pager/remote with care if the LCD display and/or the
electronics may be damaged if subjected to abuse. The AAA Cell
1.5V alkaline battery can easily be replaced by sliding open the
battery access door on the back of the remote. Battery life will vary
depending on usage. The LCD screen will display a low battery
icon when the battery is low.
BUTTON FUNCTIONS
BUTTON 1(Lock Symbol):
·
Press and release to Arm/Lock system.
·
Press and Hold for more than 3 seconds to activate “Panic” feature.
·
When ignition on – door locks.
BUTTON 2 (Unlock Symbol):
·
Press and release to Disarm/Unlock system, or reset a cycle.
·
When ignition on – door unlocks.
BUTTON 3 (Trunk Symbol):
·
Press and Release to activate trunk pop (Auxiliary output #1)
·
Press for 2 seconds for CarJack option 13 and 14 must be programmed.
BUTTON 4 (Start Key Symbol):
·
Press and release for silent arm/silent disarm.
·
Press and hold for more than 3 seconds to activate Aux #2.
·
When arming within 5 Seconds press and hold for 2 seconds to disable sensor.
LCD 2-Way Pager
#2 DISARM
UNLOCK
LCD
SCREEN
#4 SILENT
#1 ARM
LOCK
#3 TRUNK
#5 RECALL
CAR I or II
FIXED
ANTENNA
AM
