10
OPTION PROGRAMMING Cont.
6. ACTIVE RE-ARMING
Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door
has not been opened. This is handy if the vehicle is accidentally disarmed (via the Transmitter in your pocket)
without you knowing it.
7. DOUBLE UNLOCK PULSE
The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for
interfacing this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are
found on some Nissan, VW, Toyota, and Lexus vehicles.
8. SILENT ARMING DISARMING ( CHIRP DEFEAT )
With this feature, the system can be programmed to Arm and Disarm without the siren chirp using the regular
Lock/Unlock Button. Flashing parking lights will be the only Arm/Disarm confirmation.
9. PARKING LIGHTS ON WITH DISARM
Keeps parking lights on instead of 2 flashes when system is disarmed to assist in locating your vehicle in a
crowded parking lot or structure. Light will stay on for 30 Sec. or until Ignition is turned on.
10. DISARM WITH AUX. OUTPUT 1 ( TRUNK POP )
Controls whether the system will DISARM when the trunk pop / AUX. feature is used. When the option is
turned on, the alarm disarms when opening trunk or using an AUX. device controlled by the Gray output wire.
11. SILENT ARM / DISARM WITH REMOTE BUTTON #2 ( QUICK PRESS )
With this feature, the system can be programmed to Arm and Disarm without a siren chirp using a short press
and release of Button #2 on the remote transmitter.
12. DOOR LOCK/UNLOCK PULSE TIME
Controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The 3 sec. setting may be required
for 1980’/90’s European Vehicles that require a long pulse to do Vacuum door lock systems.
13. ACTIVE, PASSIVE, or FULL TIME CARJACK PROTECTION
This feature controls the type of Carjack protection the alarm will provide. There are 3 selections: Button 1
(Lock) = Active protection. Button 2 (Unlock) = Active and Passive protection. Buttons (1+2) = Full-Time
protection. Option number 14 must be enabled to allow Carjack functions to operate.
