9
OPTION PROGRAMMING
NOTE: Options can be instantly restored to Factory Default Values.
To restore default values:
Perform step #1 above, then press buttons (1+2) together. The siren and horn will chirp 4 times and
lights will flash 4 times. Turn OFF Ignition. All programming options will be restored to * Default *
values (See chart above).
1. HORN CHIRPS PULSES
This option controls the system’s Horn-honk output. There are 3 selections: Button 1 (Lock) = Horn Pulse only
when alarm is tripped. Button 2 (Unlock) = Horn Chirps for Arm / Disarm and Pulse when tripped. Buttons
(1+2) = Horn Chirps for Arm, Disarm, and Pre-warning protection. The horn output pulses when triggered.
2. PASSIVE ARMING and CHIRP COUNTDOWN
This option controls the Passive (Automatic) Arming feature. If ON, arming will occur 30 Seconds after the
ignition is turned off and the last door has been closed. The LED will begin flashing rapidly while counting
down. If a door is reopened, the system will wait for the door or zone to close before arming. The unit will
flash the lights once. Doors will lock if passive locking is selected. Factory default setting is OFF. If Passive
Chirp countdown is selected, the System will produce a siren chirp every 2 seconds during countdown until
the system arms.
Note: If you re-enter the vehicle you must turn ignition key ON and OFF for passive
arming to reactivate.
3. PASSIVE LOCKS / CUSTOM OVERRRIDE ( ALSO SEE CUSTOM OVERRIDE SECTION, page 11 )
This option controls whether the doors will lock when Passive Arming occurs
. Note: This feature may
increase the risk of locking keys in the vehicle.
4. IGNITION CONTROLLED LOCKS
This option controls whether the locks are controlled by Ignition. There are 3 selections: Button 1 (Lock) =
Lock/Unlock with vehicle Ignition. Button 2 (Unlock) = No ignition locks. Buttons (1+2) = Ignition lock only.
Doors will not lock if they are open to prevent locking the keys in.
5. 5/60 Sec. DOOR OPEN WARNING
This setting changes the delay time in which the alarm system begins to monitor the Door circuit. This option
can prevent the alarm from giving warning chirps on vehicles with a delayed dome light.
