17
OPERATION INSTRUCTIONS
ACTIVE ARMING
To arm the alarm and lock the doors, press the #1 (Lock Symbol) button on the transmitter. You will hear a
single siren chirp and the lights will flash once. The system will arm, the doors will lock and the starter will be
disabled if these optional features are installed. The red LED in the vehicle will start flashing after 5 seconds.
After a short delay to allow vehicle and electronics to stabilize the system will be completely armed.
ALARM TRIGGERING
If there is an intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for
45 seconds. After 45 seconds the system will automatically shut off and re-arm to continue to protect the
vehicle. If a door is left open, the unit will cycle a second time and still continue to protect the other un-
tampered zones.
DISARMING
Press the #2 (Unlock) button on the transmitter to disarm the alarm. You will hear 2 siren chirps and the lights
will flash twice. The LED stops flashing. Door will unlock and dome light will turn on if the options are
installed.
TRUNK/HATCH POP (REMOTE AUX. OUTPUT 1, OPTIONAL)
To pop the trunk (if optional feature is installed), press and release Button #3 (Trunk Symbol) on the
transmitter.
If the system is armed, pressing Button #3 may or may not trip the alarm system when opening
the trunk depending on programming option (10). See programming option chart for more details.
REMOTE PANIC PROTECTION
To sound the alarm upon command (panic), press and hold the Button #1 (Panic) for at least 3 seconds until
the siren sounds. Press Button #2 (Unlock) to reset panic mode.
PRE-WARNING SHOCK PROTECTION & SENSOR ADJUSTMENT
If a low-level shock to the vehicle is detected, pre-warning protection will activate sounding 5 quick siren chirps
and 1 light flash. If a hard impact is detected the shock sensor should trip the alarm system. Once it is
mounted, adjust the sensor as needed by turning the adjustment screws clockwise to increase or counter-
clockwise to decrease the sensitivity. The sensor is also equipped with 2 small indicator lights to ease the
adjustment process. Green light = Pre-warning disturbance (5 siren chirps). Red light = A full alarm trip.
