CARJACK PROTECTION
REMOTE OPERATED CARJACK (JUMPER PIN P9)
This feature provides Active Carjack protection through the remote control and must be enabled before use through
Jumper Plug J9 programming. When the Ignition is on (vehicle is running), press and hold the #2 Button (UNLOCK)
for more than 2 seconds. The parking lights will flash 2 times and the LED will begin to flash rapidly to confirm the
Carjack countdown sequence. 30 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-
warning chirps turning into a full system activation with siren / flashing light pulses for up to 5 min. If the Ignition is
turned off during a Carjack trigger the siren and lights stop but Carjack protection is still active. The Siren and Lights
will resume if the Carjacker tries to turn the Ignition back ON.
To reset Active Carjack, press Button #2 (UNLOCK) on the remote and the siren will chirp once, or turn the key
on and press and hold the override button for at least 5 seconds.
SWITCH-CONTROLLED & FULL TIME CARJACK (PINK WIRE CONFIGURATION)
This feature can provide Passive or Manual control Carjack protection depending on the configuration of the Pink
Carjack wire of the alarm system. To use these two types of Carjack protection, the Pink wire must be connected to a
12V toggle/momentary switch or to +12V Ignition Power. See Below for further descriptions and the
OPTIONAL CARJACK WIRING section.
SWITCH-CONTROLLED:
This configuration will enable the vehicle owner to activate a Carjack countdown by pressing a designated toggle
or hidden button (not included with kit) during a Carjack situation. A Carjack countdown will begin under the
following conditions: Ignition is ON (vehicle is running), the button or toggle switch is pressed, and the door
opens/closes. Upon these 3 events, in that order, the alarm will start a Carjack countdown. After a delay of one
minute, the system will begin chirping for 20 seconds then trigger into a full cycle for up to 5 minutes. To reset
this Carjack mode, Ignition must be ON then press and hold the override/program button 5 seconds until LED
goes out.
FULL-TIME [Permanent] CARJACK:
We recommend that this configuration this mode should only be used in serious situations. When the Ignition is
on (vehicle is running), anytime a door is opened the Carjack countdown sequence will be initiated. There will
be 2 light flashes and the LED will change from solid to quick pulsing as confirmation of a countdown sequence.
To reset FULL TIME Carjack, the Ignition has to be ON, then press and hold the override/program button 5
seconds until LED stops pulsing. The LED will be on SOLID when in this mode anytime the Ignition is ON (or
while driving) as a reminder that Carjack is waiting for a door to open.
Summary of Contents for CS-2004 WDC
Page 17: ......
