PROGRAMMING
OPTION DESCRIPTIONS (SEE CHART ON PG. 6)
10/60 Sec. DOOR OPEN WARNING
This setting changes the delay time in which the alarm system begins to monitor the Door, Hood, or Trunk Zones. This
is helpful on vehicles with a delayed dome light to prevent the alarm from giving warning chirps due to the vehicle’s
dome light staying on. Factory Default setting is 10 Sec.
SILENT ARMING /DISARMING (NO CHIRPS)
With this feature, the system can be programmed to Arm and Disarm without the siren chirp. Flashing parking lights
will be the only Arm/Disarm confirmation. The Factory Default setting is OFF.
ACTIVE RE-ARMING
Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not
been opened. This is handy if the vehicle is accidentally disarmed (via the Transmitter in your pocket) without you
knowing it. The Factory default setting is ON.
PASSIVE CARJACK
This feature programs the alarm system’s Carjack Mode to be in Passive Carjack Mode. This mode should only be
considered in serious situations. In this mode, if a door is opened when the Ignition is on or the vehicle is running,
Carjack countdown sequence will always be initiated. After 90 seconds the unit will pre-warn and then actively start a
Carjack cycle with siren and flashing lights for up to 5 minutes. To reset or prevent this cycle from starting, the
program/override switch must be pressed 3 times. The Factory Default setting is OFF.
TRANSMITTER PROGRAMMING Note:
System can learn up to 3 different codes max.
1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the last time. (ON/OFF, ON/OFF, ON) You should hear
(1) short chirp.
2. Push the Program/Override Button for 5 seconds until the siren chirps (3) times. Release the button.
The system is now in programming mode.
3. Press Button #1 on new transmitter – siren will chirp to confirm programming. Repeat Step 3 within 5 sec. for up to
2 additional transmitters.
4. Turn off Ignition.
Note 1:
If only one transmitter is being programmed, continue pressing button #1 until dash LED flashes goes out and
the system chirps to exit programming mode to prevent unauthorized codes and noise from entering the system.
Note 2:
Programming mode is exited automatically after 5 seconds of last code transmission or once 3 new codes
have been programmed. The LED will flash go out and siren will chirp indicating program mode exit.
8
Summary of Contents for Gargoyle CS-2001
Page 12: ......
