INSTALLATION
MOUNTING:
1. The PlateCam™ SV-5350 Rear Vision System uses a super wide-angle lens for best all
around performance. The Camera will display the full width of most parking spaces up to 8
feet or even wider.
2. The SV-5350 is designed to work best on vehicles that have a license plate located at the
center and above the rear bumper. If your vehicle has a plate location that is offset to the left
side, right side, or your plate is located under the bumper then the PlateCam™ may not
provide optimum performance.
3. The design of the SV-5350 allows the camera to be angled towards the rear “Blind Spot”
behind the vehicle. The bar-bracket is designed to be mounted behind the license plate so
that only the camera is visible.
4. The SV-5350 is designed to use the existing License Plate mounting equipment
SIDE
VIEW
License Plate
Camera Lens
Mounting
Surface
Cable
Mounting
Bracket
Factory License
Plate Bolt
NOTE
Mounting Bracket should be
behind license plate
CAMERA:
1. The Camera has built-in circuitry to reverse the image so objects on the right of vehicle
appear on the right and objects on the left appear on the left when looking at a standard
monitor. (See Reverse Imaging next section for more information.)
2. The color CCD camera is maintenance-free, waterproof (IP-68) and vibration resistant.
3. This camera is NOT a night vision Infra-red camera, however the backup lights on your
vehicle and/or any ambient light in the area should allow the system to still be useful at night
in most installations.
4. The camera is completely electronic. There are NO manual adjustments for focus, etc.
