4
5
Installation Instructions
1.
Mount the mirror/monitor
1) Take the two belts and slide them into
the slots on the top rear of the mirror
with grooved side of the belt facing
down.
2) Take the buckles and slide them into
the lower slots on the rear of the
mirror with the buckle facing down
toward the strap.
NOTE: The large opened rectangle on the buckle will face away
from the strap.
3)Mount the new rearview mirror/monitor onto the existing one.
Add the rearview mirror onto the
existing mirror from one side with
one fixed belt. Then fasten the
other belt on the other side of the
mirror. To prevent the mirror from
falling off, tighten the belts until
secure to the factory rearview mirror
on both sides.
4)Cut off excess part of straps.
2.
Install the Adapter Box
Connect the adapter box cable to the rearview mirror/monitor cable.
Route the monitor cable behind the headliner of the windshield. And
then Wiring the System:
1). RED FUSED WIRE: +12 VDC ACCESSORY SOURCE
Connect this wire to a source that is 12 volts (+) when the Ignition
key switch is turned on, and 0 volts when the ignition key switch
is turned off.
