— Appendix
B
B
35
•
Make sure you have fresh batteries. With weak
batteries the UC-525 may have learning prob-
lems.
The UC-525 does
not react to button
presses of the
original remote in
learning mode
•
Point the original remote to the bottom of the
UC-525. The learning eye is at its bottom.
You see an “error”
display during the
learning proce-
dure.
•
Try the learning procedure again. Repeated
“error” messages probably indicate that the
UC-525 does not recognize the particular IR
code.
You see an “error”
display during
operation.
•
The button that you pressed has not been con-
figured. Configure the button using the
learning procedure.
The RECORD
button does not
work
•
A feature of the UC-525 prevents the record
function of your Tape or VCR from starting un-
intentionally. Hold the RECORD button for
about 2-3 seconds for the command to be sent
to the VCR.
Problems learning
from 2-way re-
motes
•
Some remotes return a confirmation signal
from the device, which can confuse the learn-
ing capability. The device should be prevented
from sending this signal during the learning
procedure. Turn off the device while program-
ming, or go to another room. Alternately, move
The UC-525 out of the line-of-sight of the de-
vice immediately after programming a button.
Problems learning
repetitive com-
mands, such as
Volume Control
•
Delete the IR code for the respective button
and try learning it again by holding the volume
button on the original remote until you see the
“OK” icon.
•
Delete the IR code for the respective button
and try learning it again by pushing the volume
button on the original remote control only
briefly.
Problems learning
sound field com-
mands from
SONY Amplifiers
•
See Appendix E
