Crivit Outdoor 7706 11000000, Translation Of Original Operation Manual

26  GB

   Tips for the best cooling output 

and energy saving

   Select a location which is well ventilated and 

protected from sunshine.

   Only place pre-cooled products into the coolbox.
   Do not open the coolbox longer than necessary.
   Don‘t leave the cool box lid open longer than 

necessary.

   Ensure that the coolbox is not packed too full 

and that the air can circulate adequately be-
tween the coolbox contents.

   Exchanging the 12 V fuse

See also fig. C.

   To exchange the fuse 

6

, first twist off the red 

plug cap 

3

 from the plug.

   Remove the fuse 

6

.

Note:

 If the thin metal connection in the middle 

between the two metal caps is broken, then the 
fuse is defective and must be replaced.

   Insert the new fuse carefully.
   Press the contact springs 

7

 together, put the 

red plug cap 

3

 back on and tighten it again. 

The plug is now ready for operation.

   Possible  malfunctions

Firstly check whether you have correctly followed the 
instructions for using the coolbox, then also check:
-   Is the connection cable correctly connected 

and does the cigarette lighter of your vehicle 
function properly?

-   Have you set up the coolbox in such a way, 

that the air can circulate freely and that ventila-
tion of the cooling unit can occur?

-   Is the fuse in the plug of the 12 V connection 

cable OK?

If you can not rectify the malfunction on your own, 
please contact our Customer Service (see chapter 
on „Service“).

   Cleaning and Care

   Do not use any abrasive cleaning agents to 

clean the product. If you do, there is a risk of 
damage to the product.

   Before any cleaning, pull the plug of the con-

nection cable out of the cigarette lighter. Oth-
erwise there is a risk of electric shock.

   Never clean the coolbox under running water. 

If you do, this could result in damage to the 
electrics.

   Remove the cool box cover before cleaning.
   Use a damp cloth and mild washing-up liquid 

to clean the cool box lid.

   Use a damp cloth and a mild soap solution for 

cleaning the bottom section of the coolbox.

   Use clean water to rinse off those parts cleaned 

with soapy water.

   Recommended  accessories

-   AC/DC power supply unit 230 / 12 V:
 

 For connecting the coolbox to a 230 V power 
source

- 

 DC/DC  transducer  24 / 12 V:

 For connecting the coolbox to a 24 V power 
source

- 

 Battery  monitor:

 Prevents the vehicle battery from running down 
too far.

Recommended accessories are available under: 
www.ipv-service.de

   Disposal

 The packaging is made of environmen-
tally friendly materials, which may be 
disposed of through your local recycling 
facilities.