Crivit 104999, Assembly Instructions Manual

8

GB/IE

Caution: The frame is under tension 

when folded and will always return 

to the tent form. Make sure that this 

tensioning force does not cause you any 

injuries.

1.  Remove the article from the bag.

Caution: Hold the article tightly when 

removing the rubber band. 

2.  Remove the rubber band and throw the  
  article into the air.
3.  Fix the four guy-ropes and the four eyelets  
  below the article using the tent pegs and  
  close the hook-and-loop fasteners around the  
  crossing tent poles (figure B). 

Disassembly

NOTE!

Disassemble the tent, if possible, when clean 
and dry to prevent the formation of mould and 
mildew. After disassembling in rain, immedia-
tely dry the tent. Clean all the parts thoroughly 
before packing them away.
1.  Remove the tent pegs and the guy-ropes.
2.  Grip the back tent pole at the bottom  
  (figure C).
3.  Now take the upper tent poles one at a time  
  and finally the bottom tent pole with the  
  opening (figure D). 
4.  Hold the middle of the tent poles tightly in  
  one hand.

Important: Hold the tent poles tightly 

and do not let them go. The tent poles 

are under tension and could injure you. 

5.  Stand the article upright in front of you and  
  keep holding the tent poles in the middle  
  (figure E). 
6.  Use your free hand to grip the upper tent  
  poles in the middle and press them from  
  above all the way down onto the tent poles  
  at the bottom (figure F). 
7.  Pull the tent poles inwards towards yourself  
  (figure G).
8.  Put the tent poles that you are still holding  
  over one another. Make sure that the tent  
  poles with the rubber band are on top  
  (figure H). 

9.  Place them all tidily above one another and  
  pull the rubber band around the article.  
  Put the article, the tent peg sack with the tent  
  pegs, and the guy-ropes in the bag, and  
  close the bag (figure I). 

Maintenance

In the case of small tears and holes, use a repair 
kit from a specialist shop. Immediately replace 
broken tent poles. Oil the zips a little if they 
become stiff.

Care

Brush dirt off the dry tent surface; if necessary 
treat with clean water. Do not use a chemical 
cleaning product. Seal the tent seams from time 
to time. For this, use a commercial seam sealer.

Storage

Store the product in a dry place to prevent the 
mould and weather marks. If it is not used for 
a longer period, take the product out of the 
packsack and store it in a dry place out from 
direct sunlight.

Notes for disposal

Please dispose of the packaging and product 
separated according to materials and in an 
environmentally-friendly manner! Dispose of the 
product through an approved waste disposal 
firm or by using your local municipal administrati-
on. Observe the current applicable legislation.

3 years warranty

The product was produced with great care and 
under constant supervision. You receive a three-
year warranty for this product from the date of 
purchase. Please retain your receipt. 
The warranty applies only to material and 
workmanship and does not apply to misuse or 
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this 
warranty.