18
Storage, cleaning
It is recommended that the product be thorough-
ly cleaned and dried after being used.
Remove small stones or other objects that may
have remained on your wheels. Dry off wet or
damp ball bearings with a clean cloth.
Oil the bearings from the outside with a suitable
bearing oil to prevent rusting. Always store the
product in a dry place.
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the packa-
ging materials out of the reach of children.
Notes on the guarantee and
service handling
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
With regard to complaints, please contact the
following service hotline or contact us by e-mail.
Our service employees will advise as to the
subsequent procedure as quickly as possible.
We will be personally available to discuss the
situation with you.
Any repairs under the warranty, statutory gua-
rantees or through goodwill do not extend the
warranty period. This also applies to replaced
and repaired parts. Repairs after the warranty
are subject to a charge.
IAN: 292955
Service Great Britain
Tel.:
0871 5000 720 (£ 0.10/Min.)
E-mail: deltasport@lidl.co.uk
Maintenance
Replacing the wheels (Fig. I)
Important! Please observe the technical
data. Wheels that have a different dia-
meter can change the riding properties
and, in some cases, possibly endanger
the user.
Do not use wheels that cannot be per-
fectly mounted.
Never mount wheels that are larger
than the product’s original wheels.
Wheels wear out. This wear and tear results from
many factors, for example the ground, the user’s
size and weight, the weather conditions, the ma-
terial of the wheels and their durability. It is thus
necessary to replace them from time to time.
• Loosen the axle bolts (19) with two size 5
Allen keys.
• Pull out the axle bolts and remove the wheel
(20).
• Install the new wheel and secure it with the
axle bolts.
After replacing:
Do not use if the wheel grinds on the
sides following replacement!
Make sure that all screws are still se-
cure and have not loosened after the
first few minutes of riding.
Tighten the wheel again to make sure
that it runs smoothly and that no noises
are coming from the bearings.
Exchanging the ball bearings
(Fig. J)
• Remove the wheels (20) as described.
• Press out one of the bearings (22) on the
spacer (21) by pressing with an Allen key
and remove the spacer.
• Press out the other bearing (22) by pressing
with an Allen key.
• Push in a new bearing. Turn the wheel over,
insert the spacer and then push in a second
new bearing.
• Secure the wheels again.
GB
