Visit us at
crlaurence.com
for international toll free information 6
A
C.R. LAURENCE Co., INC.
OPERATION
Initial Operation
1. Insert charged battery in handle and secure
with release button. The spring must snap
into place.
2. Separate the battery from the tool by pressing
the release button below the handle.
Charging Process
1. Carefully insert the battery into the base of
the tool. Pay attention to the correct
direction and do not insert the battery
the wrong way.
2. Insert the output plug of the device into the
left side of the base.
3. Insert the power plug of the device into
electrical socket (up to 230V).
4. When the red indicator lights up the battery
is being charged. This process lasts
approximately 1-1.5 hours (for fast charge).
The red indicator lamp switches automatically
off after 1-1.5 hours (for fast charge), and
the green indicator lights up. This means that
the battery has been fully recharged. Only then
can the power plug be pulled out of the socket.
The battery can then be taken out of the base
and used immediately.
CAUTION
:
• The battery must be charged up before you first use your machine. The battery only reaches its
full capacity after several charges.
• Avoid repeated consecutive rapid charges of the battery. Do not recharge after using only briefly.
• The battery and the power supply unit warm up during the charge process. This is not a malfunction.
Cordless Drill
Battery
Release Button
1
2
3
Plug (AC)
Charger
Battery
Red Indicator
Green Indicator
1
2
3
4
5
1
3
2
1
2
5
4
3
