FMUX/S-4E1-E2 Multiplexer
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567
Copyright © 2007 Cronyx
36
'
SNMP' menu
The '
SNMP
' menu is designed for setting network IP addresses and SMNP protocol pa-
rameters:
SNMP
Mode: Normal; Sensor=Open
Link: Ok
MAC address: 00-09-94-ff-ff-ff
1. IP address/netmask: 144.206.181.187 / 24
2. Gateway IP address: 144.206.181.254
3. Get community: public
4. Get IP address/netmask: 144.206.181.0 / 24
5. Set community: cronyx
6. Set IP address/netmask: 144.206.181.0 / 24
7. Traps: Enabled
8. Authentication traps: Disabled
9. Trap community: alert
0. Trap destination IP address: 144.206.181.72
Command: _
The following parameters should be set for the operation of the SNMP port:
•
'IP address/netmask: ...'
– the multiplexer SNMP port IP address and subnet mask
length;
•
'Gateway IP address: ...»
– routing gateway IP address.
The following parameters must be set for management over the SNMP protocol:
•
'Get community: ...'
– the password for information query;
•
'Get IP address/netmask: ...'
– the IP address and subnet mask length for information
query access restriction;
•
'Set community: ...'
– the password for parameter settings;
•
'Set IP address/netmask: ...'
– the IP address and subnet mask length for parameter
setting access restriction;
•
'Traps: ...'
– enabling or disabling ('Enabled' or 'Disabled') emergency state trap send-
ing;
•
'Authentication traps: ...'
– enabling or disabling ('Enabled' or 'Disabled') unautho-
rized access traps;
•
'Trap community: ...'
– password for sending emergency event traps;
