- 21 -
Returns “0” (OFF), “20” (20mV) or “50” (50mV).
The DO5003 does not have this facility, and sending this query will generate a
“query error”.
4.6 System Related Commands
DISPlay:BRIGhtness <ON|OFF> or <1|0>
Turns the front-panel display backlight on or off. Default at power-up is on.
DISPlay:BRIGhtness?
Returns “0” (OFF) or “1” (ON).
SYSTem:BEEPer
Issues a single beep immediately.
SYSTem:BEEPer:STATe <ON|OFF> or <1|0>
Enables or disables the front-panel beeper.
SYSTem:BEEPer:STATe?
Returns “0” (OFF) or “1” (ON).
SYSTem:VERSion?
Queries the SCPI version to which the instrument conforms.
The DO5000 is not compliant and returns the message “NOT SCPI COMPLIANT”.
SYSTem:TIME <
hh
>,<
mm
>,<
ss
>
Set the system clock time. Use 24 hour clock format.
SYSTem:TIME?
Queries the system clock time. Returns “hh,mm,ss” in 24 hour clock format.
SYSTem:DATE <
yyyy
>,<
mm
>,<
dd
>
Set the system calendar date.
SYSTem:DATE?
Queries the system calendar date. Returns “yyyy,mm,dd”.
*IDN?
Read the instrument’s identification string. This is of the form:
“<
manufacturer
>,<
model no
.>,<
serial no.
>,<
software version
>”
The serial no. field is not used.
e.g.
“Cropico,DO5000,0,Ver3.0”
*RST
Clears all pending operations, and resets the instrument to the default RESET
condition as described in the instrument user manual with two exceptions:
1) No change is made to the remote interface parameters (interface type,
baud rate and IEEE address).
2) The trigger mode is set to SINGLE (INITiate:CONTinuous OFF).
For IEEE only, this also resets the Operation Complete Command State and
Operation Complete Query State (clears bit 0 of Standard Event Register).
