HT-OMSMART-A
10
SECTION 3
PRODUCT IDENTIFICATION, SHIPPING & SPECIFICATION
Standard nozzles are ALBUZ 80 degree ceramic hollow
cone nozzles (brown and yellow).
The feed to all spray rings is fitted with a “non-drip”
diaphragm check valve with integral stop cock.
Spray rate capability for the Quantum Mist™ Smart
Sprayer ranges from 150 to 2000+ L/ha depending on
nozzle options.
Boom & Fan Frame
Robust powder-coated, heavy duty steel booms support
the galvanized “fan frames”. Booms are position sensing
and can be hydraulically folded to most conventional row
widths required via the Fusion controller.
Spray fan orientation is controlled via a pull rod /
parallelogram unit so that the fans remain square to the
target and park flat against the sprayer for transport.
Rear/inner booms are manually adjusted.
All fan frames feature a breakaway system.
2-Row and 3-Row
Boom configuration for a two row sprayer is “normal”,
however the 2-Row, 2-Row with Recapture or 3-Row
systems uses the unique “Hanger” style mounting (as
shown) at the end of the boom arm.
Chassis
Hot-dipped galvanised full-length heavy-duty chassis with
self-tracking drawbar, slide-out step & jockey stand.
Suspension
Walking beam tandem axle is fitted on all models.
Wheels & Tyres
11.5/80 x15.3 wheels with tubeless tyres are fitted as
standard. Flotation tyres available as options.
Recapture System
An optional 2-row drift reduction & recapture system can
be fitted to a 2-row QM Smart Spray. This is ideally suited
to cooler climate vineyards.
The system is modular and can be removed if the benefit of
drift control or recovery is not required.
Captured “over-spray” is returned to the sprayer tank via a
venturi suction system.
Speed Sensors
Proximity sensors are used for Fan speed, Pump speed and
wheel (travel) speed.
Tractor required
Power required at the PTO on flat terrain:
• 2-row - 40 HP
• 3-row - 65 HP
• 3-row / 18 fan / 4000 Lt - 90 ~ 100 hp
If not using a Micro Power Pack, hydraulic oil required will
be dependent on sprayer model & configuration, ranging
from 36 to 108 litres per minute at pressures up to a
maximum of 2,750 psi.
Category 2 or 3 linkage connections required.
Factory Fitted Options
• Wide Tower – will be supplied for use in row widths
greater than 3.0 metres (3.3 - 3.75)
• Recapture System
• Nozzles- Albuz 60-degree nozzles can be used in
lieu of 80-degree.
ARAG 40-degree (ceramic hollow cone) nozzles are
recommended with Optional Recapture system.
• Micro Power Pack (standard on all 18 fan models)
• Flotation tyres (31 x 13.5 – 15”) – not compatible with
the 2,000 Lt model
• Electric brakes
• Light kit
• Terracing tower
• Bio oil (for Micro Power Pack)
• Atlas 100 GPS speed sensor
• NuPoint GPS tracking, mapping and data reporting system
Machine specifications are subject to change
without prior notification.
