NEXUS AM Deactivator
Equipment and tools
v2.1
Page 11 of 26
4
Equipment and tools
The following equipment and tools are advised to use when installing and tuning the
NEXUS AM system.
4.1
General installation tools
The general tools required for installation of an EAS system (drills, screwdrivers, cutters,
etc.) are not described in detail.
4.2
Laptop computer
To properly adjust the NEXUS AM Deactivator
through Cross Point’s
software, it is strongly recommended to use a laptop computer.
A laptop will put you in full control of all NEXUS AM Deactivator
settings and features.
The following minimal requirements are set for the laptop:
Intel 1.3GHz or faster processor
Microsoft Windows XP Home or Professional with Service Pack 3 (32 bit) or
Service Pack 2 (64 bit)
Microsoft Windows Vista with Service Pack 2 (32 bit and 64 bit)
Microsoft Windows 7 with Service Pack 1 (32 bit and 64 bit)
Microsoft .NET Framework 3.5 Service Pack 1
512MB of RAM (1024MB recommended)
50MB of available hard-disk space for Device Explorer
Minimal screen resolution 1024x768 (recommended 1600x1200)
Video hardware acceleration
4.3
Software
The NEXUS AM Deactivator is interconnected through the
Cross Point Field Bus
.
To be able to adjust and configure the NEXUS AM Deactivator,
Cross Point Device
Explorer
is required.
Please refer to the
Cross Point Device Explorer User Manual
for further details on all
features and usage of this software.