MODEL
2001-21 Chassis
SECTION 1 GENERAL
1.1 Equipment Description- The 2001-21 Chassis holds two Wegener 1600 cards and can hold two
cards which have connectors through the rear panel cutout. Plus and minus 15 VDC is provided by the 2000-
01 power supply and a harness connects power to each card via a three pin mini-DIN connector. The DB9
connector provides connections to pins 4,5, and 15 of the edge card connector (pins 2, 3, and 9 of the DB9)
and ground (pins 1 and 5 of the DB9). The extrusion length is 12.17” which holds each card securely in the
extrusion. No front panels allow easy access to card controls.
2000 POWER SUPPLY
C
ROSS
T
ECHNOLOGIES, INC.
POWER
FRONT PANEL
CAUTION - RISK OF ELECTRICAL
SHOCK - DO NOT OPEN!!!
-15 GND +15
C
ROSS
T
ECHNOLOGIES, INC.
90-260 VAC
47 - 63 HZ
FUSE 2 A
J2
J3
1
5
6
9
J2
J3
1
5
6
9
REAR PANEL
Figure 1.1 Model 2001-21 Front and Rear Panels
1.2 Technical Characteristics
TABLE 1.0 2001-21 Chassis SPECIFICATIONS
Characteristics
Specifications*
Number of Card Positions 2
Indicators
Power
Green LED indicate 2000-01 Power supply on
Other
AC Power, Input.
90- 260 VAC, 47 - 63 Hz, via 2000-01 power supply
DC Power, max.
+15VDC, 1200ma; -15VDC, 500ma; via 2000-01 power supply
Size
19” W X 1 3/4” H X 12.5” D
*Specifications subject to change without notice
2 . 0
Installation
2 . 1
Mechanical - The 2001-21 has two aluminum extrusions which house 1600 PC cards. The 2001-21
has a 1 3/4” X 19” panel that can be mounted to a rack using the 4 holes at the ends. Both PC Card housings
derive ± 15V from the 2000-01 regulated power supply. Figure 2.1.Shows how a module housing and card
is assembled.
2001-21 Manual
Page 3
2/17/00