21
Maintenance
T
HIS
DOCUMENT
DESCRIBES
THE
MAINTENANCE
THAT
THE
OPERATOR
CAN
PERFORM
ON
THE
S
ENTRY
.
Figure 7
The Sentry battery compartment (battery removed)
R e m o v e t h e b a t t e r y
Use the following procedure to remove the battery.
1
Press and hold the Start switch to turn off the Sentry.
2
Hold the Sentry with the back of the device visible.
3
Loosen the hand strap.
4
Slide and hold the latch for the cover in the open position.
5
Apply enough pressure to
slide the cover
away from the latch until it stops
.
6
Release the latch and lift the cover from the Sentry.
7
Lift the bottom of the battery and remove the battery from the battery compartment.
Table 13
Items in the Sentry battery compartment
1
The
cover latch for the battery compartment
. The latch slides to release the cover. The latch automatically
returns to
the closed position.
2
The socket for the
SIM
card accepts a normal size SIM card (recommended). An adapter tray is required for smaller
SIM cards.
3
The
latch that indicates that the battery is installed
. The battery compresses the latch and the installation is
recorded in the log. When the battery is removed, the latch is released and the removal of the battery is recorded.
4
The socket for a
SAM
card. There are two sockets.
5
The product label for the Sentry.
6
The
Micro SD
card socket.
7
The battery connection points for the Sentry
.
2
3
1
7
6
4
5
Summary of Contents for Verifier Sentry
