22
Verifier
®
Sentry Operator Manual 870391 V1.1
Introduction
M a i n t e n a n c e
I n s t a l l t h e b a t t e r y
1
Remove the old battery, if necessary. See
“Remove the battery” on page 21
2
Hold the battery with the label visible.
3
Put the connection points on the battery against the connection points (
7
) in the battery compartment.
4
Press to install the battery.
5
Put the cover in position over the battery compartment.
Note
If the cover does not fit correctly over the battery compartment, check the position of the seal assembly inside the cover.
The assembly must extend under the hook for the cover latch. If necessary, slide the assembly toward the hook. When in
the correct position, the assembly stops.
6
Apply enough pressure to slide the cover toward the latch. When the cover closes, you hear the cover latch reset.
7
Tighten the hand strap.
I n s e r t a S A M c a r d
Use the following procedure to insert a SAM card. There are two SAM card connectors in the battery compartment,
next to the Sentry label.
1
Remove the battery. See
“Remove the battery” on page 21
.
2
Select an empty SAM connector.
3
Use a fingernail to unlock and move the SAM cover toward the center of the
Sentry.
4
Open the SAM cover until the cover stops.
5
Insert the SAM card into the cover. The card inserts with the chamfer on the card
as shown in the illustration.
6
Close and lock the SAM cover.
7
“Install the battery” on page 22
R e m o v e a S A M c a rd
Use the following procedure to remove a SAM card. There are two SAM card connectors in the battery compartment,
next to the Sentry label.
1
Remove the battery. See
“Remove the battery” on page 21
.
2
Select SAM card to remove.
3
Use a fingernail to unlock and slide the SAM cover toward the center of the
Sentry.
4
Open the SAM cover until the cover stops.
5
Slide the SAM card out of the cover.
6
Close and lock the SAM cover.
7
Summary of Contents for Verifier Sentry
