Issue date: 220616
Warranty
-
This
Crosswater London
product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact
:
Crosswater
London
, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-6062 fax: 508-381-6068
www.crosswater
london.
com
email: technical@crosswater
london
.com
x4
Once installed and sealed,
DO NOT
use or get wet for 24 hours.
2
Installation
3
Cleaning Instructions
l
This installation guide does not include details of
waste connection; final decision about
installation of waste connection should be
made
by a
licensed plumber
.
l
Install the waste according to the installation
instructions supplied with the waste.
WARNING: D
O NOT OVERTIGHTEN
the waste as
this may cause long
-
term damage to the bath.
We recommend to use a torque wrench to tighten
the waste by using a torque force between
25Nm or 18.5 ft/lb and 50Nm or 36.8 ft/lb.
IMPORTANT:
This bathtub is heavy and installation requires 2 people.
Crosswater
London
cannot accept responsibility for any injuries
caused to those attempting to install this bathtub without
adequate and appropriate tools or resources.
l
Remove the bathtub from the packaging using the bag with
handles.
l
Use the bag with handles to lift and move the bathtub.
l
Do not
drag the bathtub over rough surfaces or sharp
objects. Lift and place the bathtub into position.
l
Do not
drop the bathtub!
l
Check that the wedges have been supplied.
1
Installation - carriage
l
Place the 4 wedges in position.
l
Once sealed, the wedges can be
disposed of.
Clean the bath regularly with non-abrasive soap and warm water. Fully rinse after cleaning.
While Clearstone is highly stain resistant, it is recommended that bath water containing additives such as oils or salts is always drained and
rinsed immediately after use.
Please note that hair dyes and color cosmetics (eg. mascara, lipstick, face powder) may leave a slight discoloration if not removed immediately.
If any strong chemicals come into contact with the bathtub, remove and rinse immediately.
Water temperature should not exceed 49˚C/120˚F.
For a fine scratch or a slight mark, use a 1500 grade sandpaper. Gently sand the area with water. For best results, limit sanding to the smallest
possible area around the scratch. Re-polish the surface afterwards using a neutral polishing compound or toothpaste. It may be possible to
polish very fine scratches away without using abrasive papers: scrub gently with a soft brush or plastic pad (not metal scouring pad) and a
mildly abrasive cream cleaner. Afterwards scrub the whole area with plenty of clean water and re-polish as before.
If the scratch or mark is too deep and cannot be repaired using the above method, it is possible to purchase a repair kit
US-CRK
. In order to
remove the scratches, follow the instructions included with the kit.
