14
shows the type of event, date and time. Wait until all messages are displayed, or press
<
ENTER
> to cancel memory readout.
If the message exceeds 16 characters, use the right arrow to read the message.
How to Control Outputs and Devices
The keypad enables control of external devices, such as an air-conditioner or heater. To
activate or halt a device,
press
<
CONTROL
> for 2 seconds and the
number of the
device
. Up to 8 different devices can be controlled via the keypad.
When you enter control mode the system prompts you to enter device # and then
<
ENTER
> to activate or deactivate the selected device.
User Programming and Customization
How to Get into to User Program/Client Mode
There are 2 levels of program mode,
CLIENT
mode and
INSTALLER
mode. Normally the
installer will give you access to the
CLIENT
mode so you can add, delete, or change the
user codes. If you request it your installer can provide you with access to the INSTALLER
mode as well. To get into CLIENT
mode provided the system is NOT armed Press
<PROGRAM>
enter
Master code
and
<ENTER>
.
If you get a single long beep at this point , it means your code cannot access Program
mode.
How to exit program mode
To exit out of program mode press
<PROGRAM>
and
<ENTER>
.
The LCD display shows the system type, date and time.
How to Change or Add Codes
About Master code and User code
The factory default master code (123) is intended as a preliminary control of the alarm
system. After PowerWave is installed and put into service, the code can be changed to
any code known to the Master user. The Master user can define up to 99 user codes. To
limit access rights, the holder of the Master code can ask the installer to define several
User profiles.
Control Mode
- - - 4 - - - - -
PowerWave XX
TIME
DATE
www.msealarms.com.au
All manuals and user guides at all-guides.com
