13
OPERATING AND SHUT DOWN INSTRUCTIONS
OPERATING:
Main burner valves are adjustable over a full range from completely ON to completely
OFF. Note: burner valves lock when shut off. To open burner valves, you must push in and
turn counter clockwise. Do not force the controls, damage to the valves or knobs may
result.
Note: If the heat output from the charbroiler seems abnormally low; it may be caused by
the regulator flow-limiting device being activated by (i) improper lighting procedures, or (ii)
a substantial leak in the gas system. If the former is suspected; shut off the cylinder
valve and all burner valves, then carefully follow lighting procedures step by step, ensuring
all valves (including pilot) are OFF before beginning. If the latter is suspected; perform the
leak test procedure to determine if a leak has caused the flow-limiting device to activate.
• If the burner flames go out when your charbroiler is in operation; immediately turn off
all control valves. Wait 5 minutes to clear the gas before attempting to re-light the
charbroiler. If the problem persists: check the troubleshooting guide (pg.16)
• Visually check the flames every time you light your charbroiler. A good flame should be
mostly blue. If the flame is abnormally small or mostly yellow: shut off the charbroiler
and check the venturi tubes for blockage, (Fig. 2, page 6) then check the
troubleshooting guide (pg.16).
SHUT DOWN INSTRUCTIONS:
1) Turn all burner and pilot valve knobs to the OFF position.
2) Turn the LP supply valve to the OFF position.
3) Ensure all burners are extinguished.
4) Close lid(s) or install protective cover(s) until future use.
5) Disconnect LP cylinder(s) from the charbroiler when not in use.
6) Take care; your charbroiler is still hot.
CROWN VERITY INC., 37 ADAMS BLVD., BRANTFORD, ON. CAN. N3S 7V8
TEL: (519) 751-1800
FAX: (519) 751-1802
www.crownverity.com
Email: info@crownverity.com
