CROWN VERITY PS-001, Owner'S Manual

4

LIGHTING AND OPERATION INSTRUCTIONS

1) FILL WATER TANK TO FILL LINE, MAINTAIN WATER LEVEL AT ALL TIMES

2) GAS CYLINDER AND REGULATOR MUST BE IN OFF POSITION

3) OPEN GAS CYLINDER VALVE, AND PLACE A LIT MATCH TO THE BURNER HEAD.

4) SLOWLY OPEN THE CONTROL REGULATOR UNTIL THE BURNER IGNITES

5) OPERATE BURNER AT HIGH SETTING UNTIL WATER BOILS THEN ADJUST TO LOWER

SETTING 

• IF IGNITION DOES NOT TAKE PLACE IMMEDIATELY, TURN OFF CONTROL

REGULATOR AND L.P. CYLINDER VALVE, WAIT 5 MINUTES AND REPEAT
LIGHTING PROCEDURE.

• Do not force the CONTROLS; damage to the Regulator valve may result. 

• Visually check the flame every time you light your Pro Steamer. A good flame

should be mostly blue. If the flame is abnormally small or mostly yellow: shut off
the Pro Steamer and check the burner for blockage.

SHUT DOWN INSTRUCTIONS: 

To prepare your charbroiler for long term storage, follow these steps:

1) Turn the control regulator to the OFF position.

2) Turn the LP cylinder valve to the OFF position.

3) Ensure all burners are extinguished. 

4) Disconnect LP CYLINDER (s) from the Pro Steamer when not in use. 

6) Take care; your Pro Steamer is still hot

7) Drain your Pro Steamer appropriately only after is allowed to cool 

CAUTION! Steam can cause severe burns, use caution when
operating the Pro Steamer, Wear protective gloves, never stand
directly in front of the Pro Steamer when opening the lid, allow water
to cool completely before draining.  Read all warnings and
instructions before operating the Pro-Steamer.

CAUTION! When lighting the burner, always hold a lit match or
extended lighter next to the burner head before opening the control
regulator.  Open the control regulator slowly until the burner lgnites,
then slowly and gradually increase the pressure to the desired heat
setting.  If ignition does not immediately occur, turn control regulator
to closed position, close L.P cylinder valve and wait 5 minutes before
attempting to re-light. Keep persons and combustibles such as
clothing well away from burner access hole