influenced by the cold parts.
1.
Remove the detachable tank and open the tank cover to fill it with desired water, the water level
should not exceed the “MAX” mark in the tank. Then place the tank into the appliance properly.
2.
Select the steam mesh, Set steel mesh into metal funnel, make sure the tube on the funnel aligns
with groove in the appliance, then insert the funnel into the appliance from the “Insert” position,
and you can fix them into coffee maker firmly through turn it anticlockwise until it is at the
“Lock
”
position.
3.
Place an espresso cup on removable shelf.
4.
Then connect the appliance to power supply. Make sure the steam control knob is on the OFF
position.
5.
Press the power switch “ ” one time,
the power indicator turns on and the coffee indicator blinks.
After finish preheating, the coffee indicator lights solidly.
Press the coffee switch , when there is
water flowing out, close the pump immediately. The purpose of the step is to pump the water of
the tank into the housing.
6.
When the lamp in coffee switch is illuminated, you should press the coffee switch again, there will
be hot water flowing out. When the lamp in it is extinguished, close the pump. The pre-heating is
finished.
MAKE
ESPRESSO
1.
Remove the funnel by turning it in clockwise. Add ground coffee steel mesh with measuring
spoon, a spoon ground coffee power can make about a cup of top-grade coffee, then press the
ground coffee powder tightly with the tamper
2.
Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from the “Insert” position, and you can fix
them into coffee maker firmly through turn it anticlockwise until it is at the “Lock
”
position..
3.
Pour the hot water in the cup,
after the cup is warmed up, empty the water in the cup and dry the
cup,
and then place the hot cup on removable shelf.
4.
At the time, the lamp incoffee switch shall be illuminated, if it is extinguished, wait for a moment,
once the lamp in it is illuminated, you should press the coffee switch wait for a moment, there
will be coffee flowing out.
Press the coffee switch again when the required amount is got, and
then the water pump stops working.
WARNING
: 1.
Do not leave the coffee maker unattended during making the coffee, as you need operate
manually sometimes!
2.After finishing making the coffee, you can take the metal funnel out through turn clockwise, then
pour the coffee residue out with the steel mesh pressed by press bar.
3.Let them cool down completely, then rinse under running water.
4. The working time for brewing single-cup of coffee is 60 seconds at most, and the water pump will stop working if
the working time exceeds 60 seconds. And the working time can be adjusted by following the operation as below. Hold
and press the coffee switch for 3 seconds under standby mode, and the coffee indicator blinks. At that time, press the
coffee switch again within 5 seconds, then the water pump starts to work. Press the coffee switch and the water pump
stops working. The setting is finished. And the adjustable working time ranges between 15 seconds and 60 seconds.
