6. After water not dropping out any more, you can pour the water in each container out then clean them
thoroughly, now you can start brewing.
Note: There may be noise and no water comes out when pump the water on the first time, it is normal, you
should turn the steam control knob to the opening position to release the air in the appliance. After about 20s,
the noise will disappear, and the water will comes out.
PRE-HEATING
To make a cup of good hot Espresso coffee, we recommend you preheating the appliance before
making coffee, including the funnel, filter and cup, so that the coffee flavour can not be influenced by
the cold parts.
1.
Remove the detachable tank and open the tank cover to fill it with desired water, the water level should
not exceed the “MAX” mark in the tank. Then place the tank into the appliance properly.
2.
Set steel mesh into metal funnel, make sure the tube on the funnel aligns with groove in the appliance,
then insert the funnel into the appliance from the “Insert” position, and you can fix them into coffee
maker firmly through turn it anticlockwise until it is at the
lock
position.(See fig. 1).
3.
Place an espresso cup (your cup) on the cup warming plate for warm and dry for collecting coffee later.
4.
. Then connecting the appliance to power supply source. Make sure the steam control knob is on the
minimum position.
5.
Press the
ON/OFF
button to
turn on the unit
, the power indicator (red) will be illuminated, make sure
the coffee/steam button is on the higher position which is the
position. Press down the pump control
button to the lower position which is the “
” position, when there is water flowing out, close the pump
immediately by pressing the pump control button again to the higher position of “
STOP
”. The purpose of
the step is that pump the water of the tank into the housing.
6.
When the ready indicator (green) is illuminated, you should press down the pump control button to the
lower position which is the “
” position again, there will be hot water flowing out. When the ready
indicator (green) is extinguished, close the pump by pressing the pump control button again to the higher
position of “
STOP
”. The pre-heating is finished. Before making coffee, first clean out the water in the drip
tray.
MAKE ESPRESSO COFFEE
1. Remove the funnel by turning it in clockwise, .Add ground coffee to steel mesh with measuring spoon, a
spoon ground coffee power can make about a cup of top-grade coffee, then press the ground coffee
powder tightly with the tamper.
