9
5-CHANNEL WIRING
The amplifier inputs are white cables. Each cable is marked with a numbered band at the end of the
cable.
1. Refer to
Figure 5
for the following connections:
Connect CH 1 signal (left-front) to white input cable 1.
Connect CH2 signal (right-front) to white input cable 2.
Connect CH3 signal (left-rear) to white input cable 3.
Connect CH4 signal (right-rear) to white input cable 4.
Connect CH5 signal (Subwoofer) to whit input cable 5.
2. Set the amplifier switch to 5 CH as in
Figure 6
. This provides the following output powers:
CH1: 50 W at 4 ohms
CH2: 50 W at 4 ohms
CH3: 50 W at 4 ohms
CH4: 50 W at 4 ohms
CH5: 100 W at 8 ohms
(These are minimum recommend loads.)
3. Refer to
Figure 5
. Connect the speakers as follows. Route the CMA-1 colored output cables
separate from its white input cables to prevent oscillations. Using crimp terminals, connect the
CMA-1 colored cables to the speaker terminals, taking care to observe the cables colors and
polarities noted below:
Blk/Wht:
CH 1 +
Left-Front Speaker
Blk:
CH 1 -
Wht/Red:
CH 2 +
Right-Front Speaker
Wht:
CH 2 –
Red/Wht:
CH 3 +
Left-Rear Speaker
Red:
CH 3 -
Grn/Yel:
CH 4 +
Right-Rear Speaker
Grn:
CH 4 -
Blu/Red:
CH 5 +
Subwoofer
Yel/Red:
CH 5 -
