Crown CT19022K Original Instructions Manual Download

Page: 18 / 116

English

•

Deflector nozzle

is used for treating one surface

and protecting the other (the heating of which is unde-
sirable, e�g� window glass)�

•

Reflector nozzle

is used for changing the air flow

direction�

•

Point nozzle

is for treating small-area surfaces as

well as for soldering�

General recommendations

•

If necessary, put an appropriate special nozzle on

gun nozzle

�

•

Prepare accessories required for work performance

(scraper, palette knife, brush, etc�)�

•

Switch on the power tool, adjust the air flow and

temperature as described above�

•

After the operation completion, place on / off

switch

in position "1" and let the power tool run for a

while so that it cools down, and only after that you can
switch it off�

Special recommendations for performing different

types of work (see fig. 4-8)
Paint and coatings removal (see fig. 4)

- install

flat nozzle

, heat the surface area until the coat-

ing softens, and remove it with a palette knife or
scraper

�

Lacquer and paint coatings removal from window

frames (see fig. 5)

- install deflector nozzle

correctly

(to protect the glass), heat the surface area until the
coating softens, and remove it with a palette knife or
scraper

�

Forming plastic pipes (see fig. 6)

- install reflector

nozzle

� Fill the plastic pipe with sand and close it

at both ends to prevent pipe collapse� While moving

the pipe in the hot air flow, heat it and mould it as

required�

Thawing water pipes (see fig. 7)

- install reflector

nozzle

� While moving the power tool, heat a frozen

area from the edge to the middle� While heating plastic
pipes, be careful not to overheat them�

Soldering (see fig. 8)

- install point nozzle

� Apply

solder paste on the soldering area� Depending on the
material, heat the soldering area for 50-120 seconds,
and then apply solder alloy� The solder alloy must melt
under the workpiece temperature�

Power tool maintenance / preventive

measures

Before carrying out any works on the power tool it

must be disconnected from the mains.
Taking care of accessories

Keep special nozzles and scraper

clean - remove all

materials stuck to them� Regularly sharpen the blade
of scraper

- this will facilitate the work and improve

its results�

Cleaning of the power tool

An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly

flush the power tool with compressed air thought the

ventilation slots

�

After-sales service and application service

Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under:

www.crown-tools.com

�

Transportation of the power tools

•

Categorically not to drop any mechanical impact on

the packaging during transport�

•

When unloading / loading is not allowed to use any

kind of technology that works on the principle of clamp-
ing packaging�

Environmental protection

Recycle raw materials instead of

disposing as waste.