INSTALLATION AND OPERATION MANUAL, GAS SKILLETS, MODELS GTS-30, GTS-40
PART NUMBER 10093R2
5
2003-07-08
1.0 INSTALLATION INSTRUCTIONS
INSTALLATION CODES AND STANDARDS
Installation must conform with local codes, or in the absence of local codes, with the
National
Fuel Gas Code, ANSI Z223.1/NFPA 54
, or the
Natural Gas and Propane
Installation Code,
CSA B149.1
, as applicable.
1.
The appliance and its individual shut off valve must be disconnected from the gas
supply piping system during any pressure testing of that system at pressures in
excess of ½ psi (3.5 kPa).
2.
The appliance must be isolated from the gas supply piping system by closing its
individual manual shut off valve during any pressure testing of the gas supply piping
system at test pressures equal to or less than ½ psi (3.5 kPa).
Electrical grounding must be provided in accordance with local codes, or in the absence of
local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.2, as applicable.
FLUE CONNECTIONS
Do not obstruct the flow of flue gases from the flue duct located on the rear of the gas fired
tilting skillet. It is recommended that the flue gases be ventilated to the outside of the building
through a ventilation system installed by qualified personnel.
Information on the construction and installation of ventilating hoods may be obtained from the
standard for “Vapour Removal from Cooking Equipment”, NFPA No. 96 (latest edition),
available from the National Fire Protection Association, Batterymarch Park, Quincy, MA, U.S.A.
02269.
UNPACKING
Immediately after unpacking, check for possible shipping damage. If the gas fired tilting skillet
is found to be damaged, save the packaging material and contact the carrier within 15 days of
delivery.
Before installing, verify that the type of gas supply (natural or propane) and electrical service
agree with the specifications on the rating plate located on the left side console as you face the
front of the appliance. If the supply and equipment requirements do not agree, contact your
dealer immediately.
