Page 24
IQ-USM 810
IQ Digital Processor / Digital Mixer
IQ-USM 810
Reference Manual
Bump Object(s) Continuously:
similar to Bump Ob-
ject mode, except that the specified values are
added to the object value continuously at ¼ second
intervals.
Recall Preset:
enables the input to recall one of the
32 user presets. Separate presets can be recalled
for off-to-on and on-to-off transitions.
Vary Object(s) Continuously:
allows an analog in-
put voltage to control up to fifty objects within the IQ-
USM 810. Each object can be varied over a
user-specified range. This mode is typically used for
external gain controls.
4.6.3 Digital Outputs
There are sixteen digital outputs. Each output may
be controlled manually, configured to indicate the
state of a binary object or configured to indicate
whether a particular preset is loaded. There is one
indicator and six controls for each output:
•
•
•
•
•
Pin State Indicator:
indicates the logical “Pin-
High” or “Pin-Low” status of the actual hardware
output.
•
•
•
•
•
Manual:
directly controls the output state of the
corresponding pin when in Manual mode.
•
•
•
•
•
Polarity:
changes the polarity of the digital out-
put regardless of the pin control mode.
•
•
•
•
•
Mode:
controls the mode of the output pin. The
available modes are:
•
•
•
•
•
Reflect:
causes the output to directly reflect
the state of its Manual control
•
•
•
•
•
Reflect Parameter:
causes the output to re-
flect the state of the selected binary object
within the IQ-USM 810. Only a single object
may be specified.
•
•
•
•
•
Reflect Preset:
causes the output to reflect
whether the chosen preset number is loaded
within the IQ-USM 810.
