Installation and Programming Instructions for Electronic Stand-Alone Cylindrical Locks
- 20 -
Register RF Card
w
è
Mstr
PIN
#
è
8
#
è
Enter the Card
Register No. (1~999)
#
è
Place the Card in
front of the Touchpad
#
è
✱
1. Enter the Master PIN Code and press the
#
button.
Green and Red LED blinks.
2. Enter the Program Code
4
and press the
#
button.
Green and Red LED blinks.
3. Enter the One-Time User PIN Code and press the
#
button.
Beep melody with Green LED blinks.
4. Press the
#
button.
Beep melody and Number pad blink one time.
F
[Repeat steps 3 and 4 for each new one-time user (if necessary).]
F
You may register up to 3 One-Time User PIN Codes.
5. Press the
✱
button.
Completes with beep sound.
Press the
w
button to activate.
1. Enter the Master PIN Code and press the
#
button.
Green and Red LED blinks.
2. Enter the Program Code
8
and press the
#
button.
Green and Red LED blinks.
3. Enter the new RF Card Register Number(1~999) and press the
#
button.
Green and Red LED blinks.
4. Place a RF Card about 2 seconds in front of the touchpad (hear beep melody and Green
LED blinks.) and press the
#
button.
Beep melody and Number pad blink one time.
F
[Repeat step 3 and 4 for each new RF Card Register (if necessary)].
5. Press the
✱
button.
Completes with beep sound.
[For example, you wish to register two RF Cards for User 11 and User 12 respectively.
Press:
w
è
Mstr
PIN
#
è
8
#
è
1 1
#
è
place the first card in front of the
touchpad (hear beep melody and Number pad blink one time)
#
and then within 20
seconds,
1 2
#
è
place the second card in front of the touchpad (hear beep melody
and Number pad blink one time)
#
è
✱
]
- 21 -
- 20 -
