8
PL7000
USING ONLY RFID AND NO SMARTPHONE
In cases where smartphones will not be used to open the lock and only
RFID cards, you can use the BATCH mode to ADD and DELETE cards.
SETUP BUTTON
1. Push the SETUP BUTTON in the battery compartment
2. Tap the RFID card in front of the lock, when the ascending beep is heard the card is
registered as a user of the lock. All original clients will be deleted and the administrator
will be deleted as well.
SET UP BUTTON MODES
Push for 1 second
ADD users, but ADMINISTRATOR
will be DELETED if already setup
Push for 5 seconds
ADD users, but existing USERS
and ADMINISTRATOR will be
DELETED if already setup
3. Multiple cards can be enrolled, one after the other until the
setup button is pressed, otherwise enrollment will terminate
when the lock times out after a few seconds of inactivity.
4. There are 2 BATCH SET UP MODES
4.1 Push setup button for 1 second to add tapped rfid cards
and delete existing ADMINISTRATOR
4.2 Push setup button for 5 seconds to add tapped rfid cards
and delete existing administrator users
