RANGE HI/LOW Switch:
Selects the Ring Mod's Carrier Frequency control range. Set HI for bell like and
wild sounds. Select LOW for a range from vibrato to throaty modulation.
MOD DEPTH
: Sets the Carrier Frequency Modulation Range from minimal to maximum frequency swings.
MOD RATE
: Sets the Speed for theCarrier Frequency Modulation.
WAVEFORM Switch
: Selects the Carrier Frequency Modulation waveshape. Select Triangle or Square
Wave modulation.
Front Side Panel
PITCH EXP JACK :
This Mono ¼” Jack provides Carrier Frequency Expression pedal input. Use an
expression pedal with a shielded mono cable to vary the Ring Mod's Carrier Frequency.
FREQ IN JACK :
This Mono ¼” Jack provides for an External Carrier Frequency reference. Use this input to
slave to another Ring Modulator or frequency reference.
FREQ OUT JACK :
This Mono ¼” Jack outputs the Carrier Frequency reference. Use this output to slave to
another Ring Modulator or to provide a frequency reference.
Side Panels
HI-Z OUT:
This unbalanced ¼” jack provides a high impendance output signal to your amplifier, mixing
console, or other effect units.
HI-Z IN
: Unbalanced, high impedance ¼” input is optimized for a variety of input levels.
POWER ADAPTER INPUT:
Use only approved AC Power Adapter (18Vac 1 Amp)
