520 Express Series
4-3
11 - BOW THRUSTER
Press both ON buttons and the indicator
light will illuminate. Move the joystick in the
direction you wish to move the bow (
W
=
port,
X
= starboard). For example, to move
the bow to port, move the joystick to port
(
W
). This will engage the bow thruster
propeller and move the boat to port. Turn off
the bow thruster by pressing the OFF button.
The indicator light will go out showing the
bow thruster is turned OFF.
IMPORTANT
Both ON buttons have to be pressed
at the same time, this is to prevent
accidental starting of the bow
thruster.
12 - 12 VOLT OUTLET
This receptacle provides 12 volt DC power
to portable accessories such as cellular
telephones.
13 - PORT WIPER
This toggle action button controls the port
wiper. Pressing a button will turn ON the
wiper in the low speed mode. Pressing it a
second time will turn it ON in the high speed
mode. Pressing it a third time will turn the
wiper OFF and park the wiper. The LEDs
indicate if the wiper is ON and the speed
mode of the wiper.
14 - STARBOARD WIPER
This toggle action button controls the
starboard wiper. Pressing a button will turn
ON the wiper in the low speed mode.
Pressing it a second time will turn it ON in
the high speed mode. Pressing it a third time
will turn the wiper OFF and park the wiper.
The LEDs indicate if the wiper is ON and the
speed mode of the wiper.
15 - WINDSHIELD DEFOG
This switch is a toggle action switch that
controls the windshield defogger. When the
switch is pressed, the defogger will turn ON.
When the opposite end is pressed, the
defogger will turn OFF.
16 - WINDSHIELD WASHER
The WASHER button is a momentary action.
The washer will stay on as long as the
button is pressed. If a wiper(s) is not ON, the
WASHER button will energize the wiper in
low speed. The system has an off-delay
function for the wiper(s) that were energized
by the WASHER button allowing the
wiper(s) to stay ON for several cycles and
then park. If a wiper was ON prior to the
washer cycle, it will remain on at its
commanded speed both during and after the
washer cycle.
17 - FIREBOY ALARM
The display unit has an indicator lamp to
indicate fire suppression automatic fire
extinguisher status. The lamp should glow
when the ignition switch is in the ON position
indicating a charged system. Should the
system discharge, the lamp will not glow.
Refer to the Fire Suppression owner’s
manual in the Skipper’s Kit for complete
details.
18 - HIGH WATER ALARM
The alarm will sound when the high water
alarm float switch is activated.
ON
ON
OFF
CSR500-001
Downloaded
from
Cruisers
Owners
Forum
http://www.CruisersOwnersForum.com
