6-4
520 Express Series
520 Express Series
Windlass System
The windlass can be operated from the
keypad or by the foot switches, located near
the windlass.
WARNING
When using the Winch DO NOT
switch immediately from one
direction to the other without
waiting for the windlass to stop as
this could damage the windlass.
Abuse is not covered by Warranty.
WARNING
The Breaker/Isolator Panel provides
protection for the main power
supply and is also a means to
isolate the circuit. The circuit
breaker provides protection for the
motor from excessive overload
current and short circuit. It does not
provide protection against
excessive heat buildup due to
prolonged instant operation or
repeated operation under overload
conditions. Make sure you give the
motor time to cool (6-8 minutes).
Abuse is not covered by Warranty.
CSR173-43
TRIM
TAB
TRIM
TAB
ZINC
PLATE
WARNING
When the Isolator Switch is ON the
system can be activated at either
the remote or the foot switches.
When system is not being used,
ensure that the power is turned OFF
at the Breaker/Isolator Panel by
pulling the button out. Firm
pressure is required to push in or
pull out the button.
Function of Clutch
1. The cone clutch engages and
disengages the chainwheel from the
winch drive. It is designed to be adjusted
with the handle provided and to provide
slippage if winch is overloaded.
2. Disengage the clutch by inserting the
clutch release handle (provided) into the
clutch nut and rotate the handle counter
clockwise approximately one turn.
Clockwise rotation engages the clutch.
Lowering the Anchor Under
Power
Proceed as follows:
1. Check that the clutch is firmly tightened
by inserting the handle provided in the
clutch nut and rotating the handle
clockwise (approximately one turn).
Downloaded
from
Cruisers
Owners
Forum
http://www.CruisersOwnersForum.com
