CRUISING ELECTRONICS
17 MOREY ROAD CABLE BAY 0420 FAR NORTH NEW ZEALAND
TELEPHONE 027 2552852 (+64 27 2552852)
don@cruisingelectronics.com www.cruisingelectronics.com
WARRANTY
In the event of malfunction or failure Cruising Electronics will, at their sole discretion, either repair or
replace the unit, providing that:
Malfunction has occurred within 12 months from the date of purchase
Any or all of the listed ratings of the unit have not been exceeded
The unit has been properly installed, with regard to correctly rated cables, fuses, switches and any other ancillary
items which could reasonably be regarded as necessary to effect a safe and workman-like installation.
The unit has not been exposed to any fluid, corrosive or hazardous substance, excessive airborne particles
The unit is returned freight paid to Cruising Electronics or their nominated agent
Proof of purchase is provided
Please note that under no circumstances can Cruising Electronics be held responsible or accept liability for
any consequential damages or loss whatsoever, incurred as a result of installing or operating this clock.
Cancelling an alarm:
To completely cancel or turn off an alarm:
Follow the procedure above, but toggle the display to show AL ---, then press
SET
To cancel the alarm once it is sounding:
When the alarm time is reached, the buzzer will sound for 30 seconds
To cancel the alarm, press
UP
or
ALARM
To activate snooze mode, press
DOWN
In snooze mode the alarm will sound again in 4 minutes, for a period of 30 seconds, for one time only
Automatic temperature display:
Move the
SLIDER SWITCH
on the top of the clock to ON
Every 20 seconds the display will show temperature for 5 seconds, then revert to time display.
This cycle will repeat until the
SLIDER SWITCH
is returned to OFF
Changing the temperature display units:
Put the clock into automatic temperature display mode, as outlined above
When temperature is being displayed, quickly press
UP.
The display will toggle between °C and °F with each press
When the
SLIDER SWITCH
is turned off, the selected unit will be retained for when manually viewing temperature
To manually display temperature:
From the Clock time display, press
SET
once
To return to the time display, press
UP
once
To dim the display:
From the clock time display, press
SET
twice
Press
UP
once. Time is again displayed, and the display is dimmed
To brighten the display again, repeat the above steps
Automatic display dimming:
An inherent feature in the design of this clock is automatic display dimming.
At 10.00 PM (2200 Hours) if the display has been set manually to ‘Bright’, it will automatically reset to ‘Dim’
At 6.00 AM (0600 Hours) it will automatically revert to ‘Bright’
It is not possible to permanently cancel this operation, but it can be manually over-ridden each time it occurs
If the display has automatically dimmed at 10.00pm, press
SET
twice, then
UP
once.
The display will again be set to ‘Bright’
