6
The detector is designed to operate on most DC12V
negative ground vehicle electrical systems. The power cord
provided with the detector has a cigarette lighter socket plug
at one end and a small connector at the other.
1. Insert the small connector into the jack on the side of the
detector.
2. Insert the other end into the cigarette lighter socket of
your vehicle.
If the detector does not operate when you turn it on, remove
the adapter from the cigarette lighter socket and carefully
check the socket for debris. Also, check the fuse in the
adapter and your vehicle's fuse box.
Replacing the Fuse
If the detector CRUNCH stops operating, the fuse in the
cigarette lighter plug might be blown. If it has blown, follow
these steps to replace it:
1. To replace the fuse, unscrew the top of the plug.
2. Remove the fuse and check the fuse to see if it has
blown. If it has, replace it.
RADAR OPERATION
Power & Volume control
Plug the adapter of the provided 12V DC power cord into
the lighter of your vehicle, and plug the small connector at the
other end of the 12V DC power cord into the power jack of
your detector. This will send power to the detector when your
vehicle is running. To turn on the detector, rotate the wheel
130.com.ua
Autogood products «130»
