019 0021
Front Pillar Speakers
6
1.
Starting at the top edge, pry out
pillar
trimpanel
to release two (2) retaining clips.
Twist
panel
retainer
to release from panel
(Figures 1 & 2).
2.
Pull bottom of trimpanel toward rear of vehicle.
Tilt trimpanel toward center of vehicle.
Disconnect wiring harness and remove panel.
3.
Pry
tweeter
out to release three (3) clips and
remove tweeter (Figure 3).
4.
Fabricate a speaker mounting bracket and
secure new speaker to bracket.
5.
Make wiring connections following instructions
on page 13. Return to this page to complete
installation.
6.
Secure speaker/bracket assembly to location.
7.
Test speaker operation and reassemble pillar
area by reversing disassembly steps.
NOTES:
Please read first
•
Instructions show factory size speakers or speakers
with adaptor brackets only. Cutting or fabrication (not
shown) will be required for other speaker sizes.
Copyright 2018 Crutchfield Corporation
1-800-955-9094
TECHNICAL SUPPORT
No speaker wiring adaptor is available at this time from
Crutchfield for this speaker location. It will be necessary to
splice wires in order to install an aftermarket speaker.
No speaker adaptor bracket is available at this time for this
location. A mounting bracket must be fabricated in order to
install an aftermarket speaker.
It is possible that the replacement speakers do not have
screws supplied. It may be necessary to acquire mounting
hardware.
IMPORTANT
!
FIGURE 1
FIGURE 2
FIGURE 3
Pillar Trimpanel
Pillar Trimpanel
Tweeter
Tweeter
Retainer
Retainer
Clips
Clips
