FIGURE 2
Shaft Supports
Installation Kit
120 90-3044P
1.
Press posts on
trimplate
into holes on
kit frame
to snap
parts together and secure (Figure 1).
2.
Use a utility knife to cut out
shaft supports
in trimplate to
create a DIN opening (Figure 2).
3.
Push clips on
support tray
into slots on rear of kit frame to
secure (Figure 1)
4.
Cut off all the tabs labeled
“A”
and
“B”
on both mounting
brackets that are shown as shaded (Figure 3). The
“C”
tabs
should be the only remaining tabs.
5.
Secure side
mounting brackets
to kit frame with
studs
and
nuts
supplied (Figure 1).
6.
Remove
DIN sleeve
from receiver and slide into opening in
trimplate. Secure sleeve to trimplate by bending the
securing
tabs
(Figure 4).
7.
Slide receiver into sleeve/kit assembly.
DIN Receiver Assembly
2
®
Copyright 2003 Crutchfield Corporation
FIGURE 4
Securing Tabs
DIN Sleeve
Bend tabs after sleeve
is inside assembly.
FIGURE 1
Trimplate
Kit Frame
Support Tray
Mounting Bracket
Mounting Bracket
Stud
Nut
Chevrolet/GMC
Tools Required
Utility
Knife
▲
Small Flat Blade
Screwdriver
3/8” Socket
FIGURE 3
Cut off A & B
(shaded tabs)
on both brackets
These “C” tabs must remain
Hacksaw
