Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, C
A
91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.021120
2 of 3
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
DIP SWITCH SETTINGS:
INSTALLATION INSTRUCTIONS:
INSTALLING THE CAMERA AND INTERFACE
1. Remove the factory radio to gain access to the factory connectors.
2. Plug in the t-harness with WHITE and GRAY connectors. (See wiring diagram on page 1)
3. Set the proper DIP Switch settings on the RVCCH-75 module. (See chart above)
4. Test the camera for functionality before installing it.
6. Use the WHITE 12V Reverse Output wire to power the camera (see wiring diagram on page 1).
DO NOT
connect the red power wire near the camera to the reverse light and insulate this red wire to avoid from
shorting.
If the vehicle has a manual transmission, the camera power must be tapped to the +12V reverse light
wire instead. In this case the WHITE 12V Reverse Output wire is not used and should be insulated to avoid
from shorting.
7. Plug in the Yellow male RCA from the camera cable to the Yellow female RCA of the t-harness with white
connectors.
8. Plug in the AV source and test for functionality.
9. Once camera functionallity has been verified. Remove the spate tire at the back of the vehicle.
10. Remove the rear panel and drill a 5/8” hole to mount the CUL-03 camera.
11. Connect the power connection per the diagram on page 1.
12. Connect the video cable of the camera to the extension cord provided.
13. The CUL-03 camera comes with parking guide lines. To disable the partking guide lines cut the thin white wire
loop on the camera cable.
14. Route the cable towards the radio and plug in the yellow RCA to the t-harness.
15. Test the camera and AV input again before re-installing the radio.
DIP SWITCH FUNCTIONS:
DIP 1 = Video in Motion Activation ON / OFF
DIP 2 = Rear View Camera ON / OFF
DIP 3 = Set to OFF
DIP 4 = Set to OFF
DIP 5 = CAN Termination Radio Side*
DIP 6 = CAN Termination Car Side*
RVCCH-75
*DIP 5 & 6
If the radio is having turn-on issues, please try the following:
Attempt 1: Set 5 & 6 to ON
Attempt 2: Set 5 to ON and 6 to OFF
Attempt 3: Set 5 to OFF and 6 to ON
1 2 3 4 5 6
ON
LED INFORMATION:
The RVCCH-75 module has 2 LEDs on the side of the Molex connector that confirms its functionality as follows:
RED LED = Confirms Power
BLUE LED: PULSING = No BUS, Pending Data
OFF = Complete Power Down
SOLID = BUS Recognized
The GREEN wire is used for a non-permanent VIM feature.
Set DIP #1 to OFF and connect the GREEN wire to +12V to
turn on the VIM feature. Use a toggle switch to be able to
turn it ON or OFF.
Rear View with VIM Integration Interface and Lip Mount Camera
for Chrysler, Dodge & Jeep Vehicles with MyGig Radio
