crystal fires JEWEL CUBE, Users Installation & Servicing Book

issue 3 

9

INSTALLATION STEPS 

TEST FOR SPILLAGE 

      
CHECK FOR SATISFACTORY CLEARANCE OF COMBUSTION PRODUCTS 
 
CLOSE ALL DOORS AND WINDOWS IN THE ROOM CONTAINING THE FIRE. 
 
TURN ON GAS SUPPLY,LIGHT THE FIRE AND SET THE CONTROLS TO HIGH 
 
LEAVE THE FIRE BURNING FOR FIVE MINUTES AND INSERT A LIGHTED SMOKE  
MATCH ON A VERTICAL PLANE 50mm INSIDE THE CANOPY AND 180mm  FROM 
EITHER SIDE OF THE OPENING  
ALL THE SMOKE MUST BE DRAWN INTO THE FLUE. 
 
IF SPILLAGE OCCURS ALLOW  A FURTHER TEN MINUTES. 
 
SHOULD SPILLAGE STILL OCCUR TURN OFF THE FIRE AND SEEK EXPERT ADVICE 
 
IF AN EXTRACTOR FAN IS SITUATED IN THE ROOM THIS TEST SHOULD BE 
REPEATED WITH THE FAN RUNNING 
 
IF THERE IS A CONNECTED ROOM WITH AN EXTRACTOR FAN,THE TEST SHOULD 
BE REPEATED WITH ALL THE DOORS TO THAT ROOM OPENED AND THE EXTRACTOR 
FAN RUNNING. 
 

INSTALLATION STEPS 

FITTING TRIMS

FIT THE TRIM WITH FOUR MAGNETS PLACED ON THE VERTICAL SIDE FLANGES 
OF THE FIREBOX(ONE AT THE TOP AND ONE AT THE BOTTOM) 
 
OFFER THE TRIM UP  AND PUSH INTO POSITION 
 
PLACE FRET CENTRALLY IN FRONT TO COVER THE CONTROLS 
 

INSTRUCT USER 
 

DEMONSTRATE THE LIGHTING AND EXTINGUISHING PROCEDURES TO THE USER 
AND REMOVAL AND REFITTING OF THE  TRIM FOR CLEANING. 
 
THE APPLIANCE SHOULD BE OPERATED  WITH THE GAS CONTROL NOT TURNED ON 
MORE THAN  LOW FOR THE FIRST FIVE HOURS OF USE TO ALLOW THE FIBRE 
LOGS  TO CURE SLOWLY. 
 
THE CURING EFFECT OF HEATING THE LOGS AND OTHER CERAMICS COMPONENTS 
WILL CAUSE AN INITIAL ODOUR. 
 
THE APPLIANCE SHOULD BE SERVICED ANNUALLY BY A COMPETENT PERSON IN 
ACCORDANCE WITH THESE INSTRUCTIONS AND THE APPLIANCE CHECKED FOR 
SPILLAGE IN ACCORDANCE WITH THE METHOD DETAILED IN THESE 
INSTRUCTIONS 
 
HAND THESE INSTRUCTIONS TO THE USER.