3. Please recycle the CrystalFlo whenever possible, otherwise dispose of responsibly
4. Ensure seal is properly installed on the Inlet/Outlet tube of the CrystalFlo Water Cartridge assembly
(may have shifted during shipment or un-packaging)
5. Align CrystalFlo Water Cartridge with openings in cooler, and push downwards into place (Figure 22).
Ensure that foam seal is pushed down and seals the reservoir completely.
6. Close the top cover (push downwards to lock into place) (Figure 23 and Figure 24). If cover does not
close completely, make sure that CrystalFlo is inserted completely.
7. Install replacement bottle (Figure 25)
8. Prime water system (see section for Prime Water System)
CAUTION! ALWAYS DRAIN WATER COMPLETELY
BEFORE SHIPPING OR STORING THE COOLER!
TROUBLESHOOTING
Water Leaks
• If water dripping from above, first try to replace the water bottle.
• If water leaking (or not bottle related), unplug Dispenser, remove bottle and call 1-800-
878-6422 for assistance
Water Not Dispensing
• Ensure Hot/Cold tanks have been primed
• Ensure that the water selection lever is fully depressed
• Ensure all internal tubing is free of any holes, cuts or cracks.
Not Cooling
• Optimum cold water temperatures will be reached after 1-2 hours of operation
• Ensure that the dispenser is at least 4 inches (10cm) from the wall to provide sufficient
ventilation
• High usage may deplete the cold water reservoir faster than the cooler can cool it
• If the water still isn’t cold, please call 1-800-878-6422 for assistance
No Hot Water
• Optimum hot water temperatures will be reached after 15-20 minutes
• Ensure that the Hot Water Switch (located at the top of the back panel) is turned on
• If the water still isn’t hot, please call 1-800-878-6422 for assistance
Dispenser is Noisy
• Ensure that the dispenser is positioned on a flat, level surface
• Ensure that the bottle is not empty. If empty, replace it
Figure 22 Figure 23 Figure 24 Figure 25
