Crystal Vision
I/O Configuration
M-VIVID User Manual R1.3
15
18 August 2022
4.4 Receiving an IP Flow
M-VIVID receives ST 2022 or ST 2110-20 video over IP flows using the 10GbE network
interfaces on the VR04, VR06 or VR07 Vision frame rear connector. Typically Eth 1 is used
for receiving and transmitting the ‘primary’ IP flows, with Eth 2 being used for the ‘protect’ in -7
protect applications.
The following example shows an M-VIVID configured to receive Input 1 using SMPTE ST
2022-7 protocol. When selecting ST 2022-7 it is necessary to configure both the ‘Network In’
and ‘Protect Network In’.
M-VIVID Input 1 Flow In
The controls highlighted in the above configuration show Input 1 of the M-VIVID set to receive
the ‘main’ flow packets on Ethernet Interface 1:1 and ‘protect’ packets of the ST 2022-7
protocol on 2:1. In this example multicast IP addresses are in use.
To successfully receive an IP flow, all IP parameters must agree with those of the transmitter.
If receiving ST 2110, the 2110 payload type and 2110 format will need to match the
transmitter.
