Assembly Instructions
A s s e m b l y S t e p 6
H a r d w a r e R e q u i r e d
Bolt
#37. Screw (M5x10 mm)
[4 pieces]
#38. Screw (ST4x15 mm)
[2 pieces]
After complete assembly: If the computer
is
not picking up your hand pulse signal
(or you are getting inaccurate readings),
Please refer to our “Troubleshooting”
section on
Page 15
for other troubleshoot
issues.
HAND PULSE SIGNAL
Troubleshooting
A.) Computer Assembly
Remove the four
Screws (#37)
that are pre-assembled
on the
Monitor (#10)
and set them aside nearby.
Attach
Monitor Wire (Upper) (#20)
to
Monitor Wire
(Middle) (#19)
. Then, attach the
Monitor (#10)
to the
bracket of
Front Post (#05)
using four
Screws (#37)
that were set aside earlier. Connect
Hand Pulse
Sensor (#21)
into the power plug hole on the back of
Monitor (#10)
as illustrated in exploded diagram.
B.) Pedal Assembly
Screw on the
Right Pedal (#12R)
to the right
Crank
(#11)
by turning the
Right Pedal (#12R)
clockwise.
Repeat on the other side using
Left Pedal (#12L)
and
turning COUNTER-clockwise.
C.) Water Bottle Holder
Remove the two
Screws (#38)
that are pre-assembled
on the
Front Post(#05)
and set them aside nearby.
Attach
Water Bottle Holder (#13)
to
Front Post (#05)
using
two Screws(#38)
that were set aside earlier.
A
B
C
Page 10
SJ-3560
