MINI TRACKED DUMPER
13
GB
Always release the clutch control
lever before changing speeds.
F a i l u r e t o d o s o w i l l r e s u l t i n
damage to the power trackbarrow.
Operate the steering levers only at
a reduced speed.
Recoil Starter Handle
The gas spring assistance provides support
when lifting and lowering the hopper.
Gas Spring Assistance
Gear Selection Lever
The gear selection lever has 4 positions: 3
forward speeds and 1 reverse. To change
speeds, move the speed shift lever to the
desired position. The lever locks in a notch at
each speed selection.
Slower speeds are for heavier loads, while
faster speeds are for transporting light loads
or an empty hopper. It is recommended that
you use a slower speed until you are familiar
with the operation of the power trackbarrow.
If the engine slows down under a load or the
tracks slip, shift the machine into a lower gear.
If the front of the machine rides up, shift
the machine into a lower gear. If the front
continues to ride up, lift up on the handles.
Operate the lever to turn left/right.
Left/Right Steering Lever
Engine On/Off Switch
The engine switch has two positions. OFF -
engine will not start or run. ON - engine will
start and run.
Recoil Starter Handle
The recoil starter handle is used to start the
engine.
Fuel Shut-Off Valve
The fuel shut-off has two positions:
CLOSED (
) - Use this position to service,
transport, or to store the unit.
OPEN (
) - Use this position to run the unit.
Throttle Control
The throttle control regulates the speed of the
engine, and moves between FAST
, SLOW
, and STOP positions.
The throttle control will shut off the engine
when it is moved to the STOP position.
Choke Control
The choke control is used to choke the
carburetor and assist in starting the engine.
The choke control slides between the CHOKE
CLOSED
and CHOKE OPEN
positions.
Choke Control
Fuel Shut-Off Valve
Throttle Control
