Clamp-on amp sensor 0-1000A
Clamp-on amp sensor 0-1000A
English, V1.3, 05.01.11
English, V1.3, 05.01.11
0970 0033
0970 0033
Introduction
4
1
Operation manual
The Probe is a clamp-on AC current probe that is designed and tested according to EN
61010-1:2002 and EN 61010-2-032:2002 (Overvoltage Category IV)
,
Safety Require-
ments for Hand-held Current Clamps for Electrical Measurement and Test, the EMC
Directive (EN 61326-1:2006 and EN 61326-2-2:2006), and other safety standards (see
“Safety Specifications”).
Warning
Before using this Meter, read the following safety information carefully. If the Meter is not
used as described in the manual, the safety features of the Meter might be severely im-
paired.
Observe the International Electrical Symbols listed below.
WARNING! Risk of electric shock.
CAUTION!
Equipment is protected throughout by Double Insulation or Reinforced Insulation.
Read the following safety information carefully before attempting to operate or service
the current probe.
•
Never use the Probe on circuits with voltages higher than 600V rms
•
Keep your fingers behind the barrier (hand guard)
•
Be extremely cautious when clamping around uninsulated conductors or bus bars.
Accidental contact with the conductor could result in electric shock.
•
Check surface of the Probe jaws; these should be free of dust, rust, dirt, and other
foreign matter.
•
Never use a Probe whose insulating protection has been impaired. Such probes
should be made inoperative by taping the clamp shut in order to prevent operation.
CS provides a warranty for this product of 12 months covering the material and workmanship
under the stated operating conditions from the date of delivery.
Please report any findings immediately and within the warranty time guaranteed by us.
Excluded from this warranty is damage caused by improper use and non-adherence to the
instruction manual.
The warranty is also cancelled once the measuring instrument has been opened provided this
is not described in the instruction manual for maintenance purposes. This is also the case if the
serial number has been changed, damaged or removed.
If in addition to the warranty service necessary repairs, adjustments or similar are carried out,
the warranty services are free of charge but there is a charge for other services such as trans-
port and packing costs. Other claims, especially those for damage occurring outside the instru-
ment are not included unless responsibility is legally binding.
CS Instruments (Asia) Co. Ltd.
Room 31, Tower B, Cambridge Plaza
188 San Wan Road
Sheung Shui, N.T.
Hong Kong
Tel:
+86 (0)755 - 8619 3164
Fax:
+86 (0)755 - 8619 3165
email:
sales@cs-instruments.com.hk
website:
www.cs-instruments.com.hk
Warranty
CS
In
stru
me
nt
s (A
sia
) C
o.
, L
td
.
